Owner`s manual

8.6 To Install Locking Clip

1. Tighten the buckled belt by pushing down hard on the child restraint and pulling hard on the

shoulder belt.

:KLOHSXVKLQJGRZQRQVHDWSLQFKWKHWZRVWUDSVWRJHWKHUEHKLQGWKHEXFNOHWRQJXH8QEXFNOH

the belt without allowing it to slip.

3. Attach locking clip to lap and shoulder belts as shown .

4. Rebuckle belt. Check that lap belt does not move

E\SXOOLQJKDUG,IEHOWORRVHQVRUOHQJWKHQVUHSHDW

procedure.

Remove locking clip when not using child restraint. Store

under it’s tab on the rear of seat.

Test installation to see if child restraint is secure.

,IQRWVHFXUHDGGLWLRQDOEHOWWLJKWHQLQJPD\EHUHTXLUHG

• Unbuckle vehicle seat belt.

• Hold belts together and remove locking clip.

• Shorten length of lap belt portion slightly by pulling belt

through latch plate. Re-attach locking clip.

• Buckle vehicle seat belt. Press child restraint further down

into vehicle seat cushion to help buckle vehicle seat belt. Test

LQVWDOODWLRQWRVHHLIFKLOGUHVWUDLQWLVVHFXUH,IQRWVHFXUH

repeat above steps until secure.

1” (2.5 cm)

