Safety Instructions
Table Of Contents
- Contents
- Models
- Warnings
- Component Identification
- Grounding
- Pressure Relief Procedure
- Setup
- Operation
- Display
- Manifold Assembly Parts
- Motor Assembly Parts
- Control Box Parts - 120V
- Control Box Parts - 230V
- Technical Specifications
- Compliance
- Graco Standard Warranty
- Graco Information
- Maintenance
- Troubleshooting
- Repair
- Pendant Battery Replacement
- Hydraulic Schematic
- Wiring Diagram - 120V
- Wiring Diagram - 230V
- Renegade TSP Torque Series Pump Parts
Repair
36 3A6884B
4. Ensure new o-rings are installed in
diverter block and remain in place.
Position diverter block on the manifold.
Align the three screws in the diverter
block with the corresponding holes in the
manifold. Secure with the three M6
screws. Torque to 6-8 ft-lbs (8.1-10.8
N•m).
5. Reattach coil on to valve. Tighten plastic
nut finger-tight to top of valve.
6. Position the 4-way valve on the diverter
block, it will only fit in one position.
Secure with the four M6 screws. Torque
to 6-8 ft-lbs (8.1-10.8 N•m).
7. Remove and dispose of plastic cover
over the plug on the terminal of new
valve.
8. Attach wire harness into terminal on
4-way valve, secure by tightening the
retaining screw.