Safety Instructions
Table Of Contents
- Contents
- Models
- Warnings
- Component Identification
- Grounding
- Pressure Relief Procedure
- Setup
- Operation
- Display
- Manifold Assembly Parts
- Motor Assembly Parts
- Control Box Parts - 120V
- Control Box Parts - 230V
- Technical Specifications
- Compliance
- Graco Standard Warranty
- Graco Information
- Maintenance
- Troubleshooting
- Repair
- Pendant Battery Replacement
- Hydraulic Schematic
- Wiring Diagram - 120V
- Wiring Diagram - 230V
- Renegade TSP Torque Series Pump Parts
Display
3A6884B 17
Change Display Units
NOTE: To change display units you must be
in the pressure screen with the pressure
display at zero.
1. Press and hold the Display Button for
5 seconds to change pressure units (psi,
bar, MPa) to desired units. Selection of
bar or MPa changes gallons to liters x 10.
Select Control Device
1. Short press Display Button three times to
move to SELECT CONTROL DEVICE
mode.
2. Press the Advance Switch on desired
control device to select it. Options
available are:
a. Manual Advance Switch.
b. Corded Pendant.
c. Wireless Pendant.
NOTE: The TSP power pack may be paired
with only one control at any time. Any
previously selected devices will be ignored
when a new device is selected.