Safety Instructions
Table Of Contents
- Contents
- Models
- Warnings
- Component Identification
- Grounding
- Pressure Relief Procedure
- Setup
- Operation
- Display
- Manifold Assembly Parts
- Motor Assembly Parts
- Control Box Parts - 120V
- Control Box Parts - 230V
- Technical Specifications
- Compliance
- Graco Standard Warranty
- Graco Information
- Maintenance
- Troubleshooting
- Repair
- Pendant Battery Replacement
- Hydraulic Schematic
- Wiring Diagram - 120V
- Wiring Diagram - 230V
- Renegade TSP Torque Series Pump Parts
Display
16 3A6884B
Display
Main Menu Operation
1. Turn power ON. Display will show
as unit powers on.
2. Once powered on, Display will show
PRESSURE (in PSI, bar, or MPa - as
selected). Refer to Change Display
Units page 17.
3. Short press Display Button and SET
HOURS will scroll past on screen.
NOTE: SET HOURS is a resettable hour
meter that may be used to monitor oil change
intervals.
a. Press and hold Display Button to
reset hours to 0.
4. Short press Display Button and
LIFETIME HOURS will scroll past on
screen.
NOTE: LIFETIME HOURS displays a lifetime
hour meter and cannot be reset.
5. Short press Display Button and name of
the selected control device will scroll
past on screen. If no control device is
selected, SELECT CONTROL DEVICE
will scroll past on screen.
a. Press and hold Display Button to
select control device. Refer to
Select Control Device page 17.
6. Short press Display Button and PRIME
will scroll past on screen.
a. Press and Hold Display Button to
enter prime mode. Refer to Prime
TSP Power Pack Procedure page
12.
7. Short press Display Button to return to
PRESSURE screen.