User's Manual

Repair
7. Reassemble the air valve (if needed): Lubricate
and install a new o-ring (106) on the air valve
(105). Lubricate and install the three o-rings
(112), then install the spacers (111). Install
gasket (107) and valve cap (108). Apply blue
Loctite or equivalent on the screw threads.
Torquethescrewsto20to30in-lb(2.3to3.4
N•m). Skip Step 8 and go to Step 9.
Torque to 20 to 30 in-lbs (2.3 to 3.4 N•m).
8. Install assembled air valve from kit: Lubricate
and install new o-rings (106 and 115). Use pipe
sealant on the threads of the valve (105) and
torque to 15 to 20 ft-lb (20.3 to 27.1 N•m). Use a
screwdriver as shown, if needed.
Torque to 15 to 20 ft-lb (20 to 27 N•m).
9. Grease the inside and threads of the cylinder
(101). With the base clamped in a vise, put the
cylinder (101) over the piston and screw into
place. Tighten with a strap wrench and torque to
50 to 60 in-lb (5.6 to 6.8 N•m).
10. Lubricate and install a new gasket (102) into the
air cylinder cap (103). Make sure the spring
(104) is in place. Lubricate the cylinder threads.
Use a strap wrench to tighten the cap (103) onto
the cylinder (101). Torque to 15–20 ft-lb (20.3
to 27.1 N•m).
11. Replace the cover (10).
3A2977D 15