User's Manual

Maintenance
Maintenance
Flushing Procedure
Note:
• Flush before fluid can dry in the equipment, at the
end of the day, before storing, and before repairing
equipment.
• Flush at the lowest pressure possible. Check
connectors for leaks and tighten as necessary.
• Flush with an appropriate cleaning solution.
1. Follow Pressure Relief Procedure, page 9 .
2. Remove the pump from the fluid container. Place
it in an empty drum. Operate it to pump out as
much fluid as possible.
3. Place siphon tube in grounded metal pail
containing an appropriate cleaning solution.
4. Set pump air regulator to lowest possible fluid
pressure, and start pump.
5. Run the pump long enough to thoroughly clean
thepumpandhoses.
6. Follow Pressure Relief Procedure, page 9 .
Cleaning
• Be sure to follow your national and state sanitary
standard codes and local regulations.
• Use appropriate cleaning and disinfecting agents,
at intervals appropriate for product processed.
• Follow cleaning product manufacturer’s
instructions.
Note: Thepumplowermust be disassembled to
thoroughly clean it.
1. Follow the Pressure Relief Procedure, page 9 .
2. Remove the pump from the fluid container. Place
it in an empty drum Operate it to pump out as
much fluid as possible.
3. Flush the system thoroughly with an
appropriate cleaning solution. See
Flushing Procedure, page 10.
4. Follow the Pressure Relief Procedure, page 9 .
5. Remove the air and fluid hoses and fittings from
the pump.
6. Disassemble the fluid pump and accessories.
See Disassemble the Pump, page 16.
7. Wash all pump parts with an appropriate cleaning
solution at the cleaning product manufacturer’s
recommended temperature and concentration.
8. Rinse all pump parts again with water and allow
them to dry.
9. Inspect all pump parts and reclean if needed.
Note
Any dama
ged rubber parts must
be repl
aced as they could harbor
microo
rganisms that can contaminate
the flui
d.
10. Immers
eallpumppartsinanappropriate
saniti
zer before assembly. Take the pump parts
out of
the sanitizer one-by-one as needed.
11. Lubri
cate the moving pump parts and o-rings,
packi
ngs, and seals with appropriate waterproof
sanit
ary lubricant.
12. Circ
ulate the sanitizing solution through the pump
and t
he system prior to use.
Tighten Threaded Connections
Before each use, check all hoses for wear or damage.
Replace as necessary. Check that all connections
are tight and leak-free.
10 3A2977D