User's Manual

Component Identification

8 3A2954D

Mounting Heater

NOTE: The Viscon HF heaters will mount anywhere a

Viscon HP heater was previously mounted. See the

dimensions listed for accessory bracket 192585 on

page 26 and the heater dimensions shown on page 29.

NOTE: Heater controls must be easily accessible.

NOTE: The mounting surface must be able to support

the weight of the heater and fluid and any stress caused

during operation.

Wall Mounting

NOTE: Use wall bracket as a template to mark bolt

holes.

Accessory Bracket 192585

(FIG.3)

1. Use lockwashers and M8 bolts (AA) of appropriate

length, not supplied, to mount bracket.

2. Install two screws (74) through spacer block and

into top two heater mounting holes until they are

about 1/8 in. (3 mm) from fully installed.

3. Lift heater and slide two screw heads into bracket

slots.

4. Install u-bracket (78) around heater and install

remaining 2 nuts (90). Tighten all nuts and bolts.

Cart Mounting

(FIG.4)

NOTE: For a 2.5 in. square tube frame cart you need to

have 2 each of cart mounting bar 183485 (CC) and

clamp 183484 (BB). See Accessories, page 26, to

order.

Place clamps (BB) around the cart vertical post (DD)

and secure to the heater mounting bars (CC) with bolts

(74) and nuts (90).

FIG. 3: Accessory Bracket 192585

ti20054a

FIG.4

ti20055a