User's Manual

Parts
22 3A2954D
Parts
Apply sealant (39) and tape (44).
Torque to 7-11 ft-lb (10-15 N•m).
Loosen setscrew (26). Turn shaft (28)
clockwise and re-tighten setscrew (26).
Turn shaft counter-clockwise. Install
knob (33) with “1” at 12 o’clock
position. Tighten knob setscrew (30).
Apply sealant (34).
Apply thermal lubricant (38) to bottom
of flange (10).
Press fit onto knob (33).
Apply thermal lubricant (38) completely
covering probe before inserting.
Wrap capillary tube of thermostat (24)
and attach strap (42).
Do not kink or
nick tube. Position wrapped
capillary tube between
thermostat (24) and wall of
enclosure (1) maintaining at least
0.6 in. from heating element.
Connect appropriate wire (240V) and
terminal end (part of item 53) to heater
terminal.
Apply adhesive (56) if required.
Apply spray adhesive as necessary on
gasket.
Locate on wall of housing near (8).
Assemble sleeve (66) to housing (67).
After bottoming parts together loosen
between 0 and 90 degrees to align set
screws (83) to sleeve flats (66).
Assemble housing (65) to sleeve (66).
After bottoming parts together loosen
between 0 and 180 degrees to align set
screws (83) to sleeve flats (66).
Cut wires from board.
2
3
4
5
6
7
9
11
12
13
14
15
16
17
18
24P016
2
75
17
65
95
31
68
81
70
79
76
66
16
17
78
77
90
83
67
84
74
75
2
83
5
5
73
96
2
2
13
73
32
2
75
2
67
16
7
69
10
6
16
17
1
14
24
9
11
5
1
9
47
18
14
52
14
43
57
15
64
25
8
53
36
12
14
87
92
54
5150
48
20
91
27
35
25
26
29
30
33
12
82
71
83
49
2
93
5
5
7
13
4
4
4
2
5
5
9
2
2
14
3
2
28,
83
ti20061a