User's Manual

Repair

16 3A2824B

Indicator Light

1. See Before Beginning Repair, page 14. Relieve

pressure.

2. Wait for heaters to cool.

3. See FIG. 7. Loosen two screws (12) and remove

shield (21).

4. Disconnect jumper wires (23, DD, EE) from back of

indicator light (9), then push light out through the

front face of the control bracket (17) by depressing

the prongs on the sides of the light. See FIG.10.

5. Press new light into control bracket (16) until prongs

lock in place.

6. Connect jumper wires (DD, EE) and reassemble

heater in reverse order of disassembly.

Heater Thermostat Switch

1. See Before Beginning Repair, page 14. Relieve

pressure.

2. Wait for heaters to cool.

3. Testing: See FIG. 10. With thermostat probe (JJ)

above 75°F (24°C), and below 160°F (71°C), the

continuity across the contacts should open when

turned off, and close when turned up toward 8. You

should hear the switch click open and closed.

4. See FIG. 7. Loosen two screws (12) and remove

shield (20).

5. See FIG. 11. Detach the two push on connectors

from thermostat switch (17). One is from thermal

limit sensor (19) at GG, and dual connector HH and

FF is from heater cartridge (21) and light (8).

6. Pull heater control knob (9) off of heater control

bracket (16) face.

7. Using a phillips head screwdriver, remove

screws (25) on control bracket face to release ther-

FIG.10

TI7011a

FIG.11

TI7012a