User's Manual

Setup

3A2797G 35

together. This creates a hydraulic fluid circula-

tion loop.

e. Turn on the power pack by navigating to the

Home Screen, Standby Mode and press .

Circulate oil for 3 minutes to purge air from

hydraulic hoses.

NOTE: Pressure should not increase while air is purged

from hoses.

f. Turn off the power pack by pressing . Look

at the gauge to verify no pressure exists in the

hydraulic hoses and the AC Power Pack.

g. Remove the 7/16 in. JIC male-male adapter

connecting the hydraulic hoses.

h. Fill both open and close gun chambers with

hydraulic fluid.

i. Attach hydraulic hoses to the gun. Tighten each

fitting 1/4 turn past hand tight.

NOTE: The hydraulic hose marked with both green and

white stripe is for the open port of the gun. The hydraulic

hose marked with only a green stripe is for the close

port of the gun.

j. Attach trigger switch cable (if applicable) to gun

and HFR.

. 18: Hydraulic Loop

NOTICE

To prevent air from entering the hydraulic hoses, do

not spill oil while disassembling the adapter connec-

tion. If spilling occurs, replace the lost fluid by man-

ually filling the hoses with hydraulic fluid.

ti14495a

. 19: Hydraulic Connections

. 20: Cable Connections

ti14496a

ti14494a