User's Manual

Spray

3A2776D 35

31. Perform the Mix and Integration Tests on page 44.

When necessary, engage trigger lock then install

the tip on gun.

NOTE: While spraying, it is best to continuously hold the

trigger. Do not release the trigger unless necessary.

This maximizes the material temperature consistency

and minimizes fiber buildup.

32. Adjust air regulator (CD) to the necessary spraying

pressure and trigger gun to spray material on a test

panel. Look at ratio screen to ensure it is reading

the correct ratio. Continue spraying on the test

panel until the desired pattern results then begin

spraying the production surface.

33. Follow Flush Mixed Material on page 36 when you

are finished spraying if the potlife of the mixed mate-

rials in the system could expire before you spray

again.

NOTE: Pot life of the mixed materials in the system is

much shorter than the dry time of dispensed epoxy

because mixed material potlife or working time

decreases with increased temperature.

TI19265a2