User's Manual

Prime Solvent Flush Pump
30 3A2776D
a. After water begins dispensing from the gun, turn
the water heater toggle switch located on the
back of the heater ON.
b. Turn the water heater power switch on the sys-
tem junction box ON.
NOTE: The water heater must be filled with fluid and
turned on at least 45 minutes prior to when flushing will
be required.
12. Close solvent pump air valve (CB) to stop pump
then trigger gun into grounded pail to relieve pres-
sure. Engage gun trigger lock.
13. Close the solvent flush ball valves on the mix mani-
fold.
ti20101a
TI19265a2