User's Manual

ManualsBrandsGraco ManualsDo-It-Yourself tools3A2776D

Setup

3A2776D 21

4. Locate the long temperature sensor with black heat

shrink sheath and a connected cable that is

tie-wrapped to the B heater power cable.

a. Cut the temperature sensor loose from the tie

wrap.

b. Insert the sensor down inside the hose bundle

so it is buried in the insulation and up against

the fluid hoses. Be sure the sensor cable will not

get pulled tight by the hose or catch on any-

thing.

c. Use electrical tape to wrap the hose bundle

from where it connects to the system to the

hose sheath. This insulates and protects the

hose bundle.

Connect the Fluid Hose Bundle

to the Mix Manifold

1. Unroll the hose bundle out to the spray area.

2. Model 262869: Connect the 3/4 in. A and 1/2 in. B

hoses to the material inlet ball valves on the mix

manifold. See F

. 20.

Model 24W626: Connect the 3/4 in. A and 3/4 in. B

hoses to the material inlet ball valves on the mix

manifold. Color code material hoses (green and

blue) with respective color identification on mix

manifold. See F

. 20.

3. Remove the U-shaped tube connectors only from

the end of the longer set of red and blue tubes. Trim

the excess tubing to fit the one set of the red and

blue tubes fully into the two brass compression fit-

tings on the aluminum heat circulation plate under

the main manifold. Tighten the compression fittings.

4. Route the purple solvent flush hoses from the mani-

fold underneath the manifold carriage and connect

to the 1/4 in. flush hose in the hose bundle.

See F

. 20.

5. Use electrical tape to wrap the hose bundle from

where it connects to the system to the hose sheath.

This insulates and protects the hose bundle.

. 19

ti20274a

. 20

Material Inlets

Solvent Inlet

ti20088a