User's Manual

Setup

18 3A2776D

Connect Feed Module Lines to

Sprayer Module

1. Connect Modules, page 15.

2. Connect the large diameter green hose from each

tank bottom outlet to the respective metering pump

inlet.

NOTE: There is a vertical swivel union at each end of

the green hose assembly.

NOTE: If desired, the green hose can be trimmed to fit

better.

a. Loosen the tank end of the hose before trying to

connect to the metering pump inlet.

b. Bend the hose as necessary to make it fit.

c. Once the vertical unions are tightened, check

that the hose clamps on the green hose are

tightened to approximately 90-100 in-lb

(10-11 N•m).

3. Connect the two hose bundles with a red air hose

on the sprayer module to the correct connection on

the respective feed module, as described below.

a. Connect the red 1/2 in. air hose to the swivel

union. See the ‘a’ in F

. 14.

b. Connect the 1/4 in. OD air signal tube to the

tube with a tube connector. This is the feed

pump pilot signal. See the ‘b’ in F

. 14.

c. Connect the small cable with an M8 connector

to the mating M8 connector. See the ‘c’ in F

14.

d. Connect the larger cable with an M12 connector

to the mating M12 connector. This is the level

sensor connection. See the ‘d’ in F

. 14.

e. Connect heater power cable to the mating

power connector. See the ‘e’ in F

. 14.

4. Connect the fluid circulation return hoses.

• The 1/2 in. circulation hose from the dosing

valve connects to the side of the A tank.

• The 3/8 in. circulation hose from the dosing

valve connects to the side of the B tank.

. 14

ti20269a