User's Manual

Setup

3A2776D 15

Connect Modules

Regardless of the chosen module configuration, the A

feed module must be on the left and the B feed module

must be on the right when looking at the front of the sys-

tem module. The A module has a blue A sticker on the

air control panel and a 1/2 in. return fitting into the tanks.

The B module has a green B sticker on the air control

panel and a 3/8 in. return fitting into the tanks.

Choose one of the configurations shown in F

. 9 then

bolt together the three modules on a flat surface. See

. 10 or F

. 11 for bolt locations. The frame bolts are

included in a bag. Once connected, the assembly can

be moved as one piece with a fork-truck.

If the modules will not be connected, they must be within

12 in. of each other and in one of the two configurations

in F

. 9 to ensure hoses and cables can reach their

connections.

If the front-to-back module configuration is used, install

the two supplied straight steel braces between each

feed module and the sprayer module, see F

. 11.

These are not used in the side-by-side module configu-

ration.

NOTICE

Do not use lift rings to lift the entire assembly. This

will damage the system. The system must be lifted

from the bottom.

. 10: Bolt Locations (Side by Side)

ti20163a

5.5 in. long

1.5 in. long

. 11: Bolt Locations (Front to Back)

ti20197a

3.5 in. long

10x

5.5 in. long