User's Manual

Setup Screens
SetupScreen4
Use this screen to set your alarm preferences. Select
to enable the a
larm, or leave the box empty to
disable the a
larm.
Key
Enter the
screen to set or change
preferen
ces.
Press to t
oggle between
and blank.
Maintenance Totalizer Alarm Enable
Flow Rate Alarm Enable
Alarm Auto Clear Enable. If enabled,
whentheflowratereturnstowithinthe
flow limit set points, the flow rate alarm
will clear on the screen and on any
attached accessories, such as a the light
tower.
Set backlight timer. Enter “00” to set the
backlight to remain on.
Exit data editing.
Move between Setup Screens, fields on
a screen, or to increment/decrement the
digits when editing number fields.
Setup Screen 5
Use this screen to calibrate your meter and
to view or set your meter k-factor. See
Calibrate the Meter, page 18, for procedure.
Key
Enter the screen to set or change
preferences.
Press to activate a field for editing or
to accept the highlighted selection on a
dropdown menu.
Move to
the right when editing number
fields.
Press again to accept the entry
when al
l digits are correct.
Start
the calibration.
Stop the calibration.
Displaysthevolumemeasuredbythe
system for the calibration test.
Enter the actual volume dispensed into
the cylinder for the calibration test.
Displays the meter k-factor. User can
set the k-factor manually. The system
automatically updates to the correct
k-factor when the meter is calibrated.
Ex
it data editing.
Move between Setup Screens, fields on
a screen, or to increment/decrement the
digits when editing number fields.
28 3A2614F