User's Manual

Setup Screens
Setup Screens
The Setup Mode is used to set up a password
(if desired) and to set parameters for controlling
andmonitoringfluidflowwiththeProControl1KE.
See Screen Navigation and Editing, page 21,for
information on how to make selections and enter
data.
Setup Scree
n1
Use this screen to view and reset the maintenance
totalizer, set the maintenance target value, and set
the batch and grand totalizer units shown on the Run
Screens. Maintenance totalizer units, shown on this
Setup Screen, are always cc.
Key
Enter the screen to set or change
preferences.
Press to activate a field for editing or
to accept the highlighted selection on a
dropdown menu.
Move
to the right when editing number
field
s. Press again to accept the entry
when
all digits are correct.
Reset Mainten
ance Totalizer - resets the
maintenance t
otalizer to zero.
Maintenance Totalizer - Displays the
current maintenance total in cubic
centimeters.
Set your desired maintenance total target
value in this field in cubic centimeters.
See SetupScreen4,page28,tosetor
disable the maintenance alarm.
Batch Totalizer Units - Select from the
following drop down options.
Cubic centimeters
Liters
Gallons
Grand Totalizer Units - Select from the
following drop down options.
Cubic c
entimeters
Liters
Gallons
Exit data editing.
Move between Setup Screens, fields on
a screen, or to increment/decrement the
digits when editing number fields.
26 3A2614F