User's Manual

ManualsBrandsGraco ManualsMetering SystemsGraco 3A2614F ProControl 1KE Kits for Management of Fluid and Air

Operation

Replace the Battery

Replace the ba

ttery only if the clock stops functioning

after disconn

ecting power or a power failure.

Sparking can o

ccur when changing the battery.

Replace the b

attery only in a non-hazardous

location, aw

ay from ﬂammable ﬂuids or fumes.

NOTICE

To avoid damage to the circuit board, wear Part No.

112190 grounding strap, and ground appropriately.

1. Disconnect power.

2. Remove the module from the bracket.

3. Attach the grounding strap.

4. Remove 4 screws, and then remove the access

cover.

5. Use a ﬂathead s

crewdriver to pry out the old

battery.

NOTE: Dispose of battery properly in an

approved container and according to applicable

local guidelines.

6. Replace with new battery. Ensure battery ﬁts

under connector tabs before snapping other end

in place.

NOTE: Us

e only Panasonic CR2032 batteries for

replace

ment.

7. Reassem

ble access cover and screws.

8. Snap th

e module back into the bracket.

20 3A2614F