User's Manual

Rear Wheel and Wheel Motors

38 3A2593B Repair

Installation

1. Install wheel sensor (4) and clamp (5) with screw

(6).

2. Connect wheel sensor connector to wire harness.

3. Verify sensor is working by turning on the main

power switch and press SETUP to display the

MEASURE screen.

4. Press gun trigger control button and rotate hub by

hand exactly three turns.

NOTE: Sensor is working properly if the measure

display reads 12.3 to 12.7 ft (3.75 to 3.87 m).

5. Install wheel (16) and four lug nuts (22).

6. Lower jack.

7. Install front shield with six screws.

8. Install tank and siphon tube.

9. Calibrate sprayer. See operation manual.

ti19099a

ti19328a

ti19329a

ti18564a

ti18589a

ti19200a

ti24917a