User's Manual

Steering Cable Replacement

32 3A2593B Repair

Steering Cable

Replacement

Removal

1. Remove tank lid and siphon tube.

2. Remove tank from unit.

3. Use wrench to remove six screws from front shield.

4. Remove front shield from unit.

5. Loosen four screws and remove pad.

6. Remove six screws and control shroud.

7. Apply parking brake. Raise front wheel off the

ground and support frame on two jack stands.

8. At the handlebar, remove locknut (3) and ball joint

(40) from handlebar. Remove ball joint (40) from

cable (48) and save if not replacing. Loosen two

nuts on cable (48) and remove from bracket.

9. On front wheel fork, remove locknut (3) and ball joint

(40) from fork. Remove ball joint (40) from cable

(48) and save if not replacing. Loosen two nuts on

cable (48) and remove from bracket.

10. Note position of cable (48) and cut off all cable ties

that retain cable to frame. Install new cable as old

cable is removed to follow same route through

frame.

ti24916a

ti19163a

ti19164a

ti19098a

ti18550a

ti19695a

ti19698a