User's Manual

Engine Replacement
3A2593B Repair 23
Installation
1. Install engine voltage regulator below engine
mounting plate with two screws. Connect regulator
to wire harness.
2. Install engine and tighten four mounting bolts and
nuts.
3. Use compressed air to feed recoil starter rope
through rope guide.
4. Feed rope through recoil starter handle and tie knot.
5. Install choke cable:
a. Make sure choke knob is pressed down.
b. Insert choke cable wire into hex-shaped pivot.
c. Insert cable sheathing under cable clamp and
tighten screw.
d. Tighten screw on hex-shaped pivot.
e. Verify proper operation of engine choke.
6. Install throttle cable.
a. Place speed lever to high speed.
b. Insert “Z” bend wire into hole furthest from pivot.
c. Place cable sheathing under clamp and pull
cable against high speed stop screw.
d. Tighten screw on cable clamp.
e. Verify proper operation of speed lever.
7. Install air filter base, element and cover.
8. Connect three wires to engine.
9. Install Clutch, see page 20.
10. Add gas and oil to engine (see Operation manual).
11. Start engine and verify high speed of 3600 rpm.
ti19706a
ti19187a
ti19708a
ti20066a
1 in. (25 mm)
ti19686a
ti19690a
ti19186a
ti19668a