User's Manual

Oil Reservoir Belt Replacement
3A2593B Repair 11
Oil Reservoir Belt
Replacement
Removal
NOTE: Ground drive belt must be removed before oil
reservoir belt can be replaced (see page 10).
1. Loosen four hold-down bolts.
2. Loosen two adjustment bolts to bring pulleys closer
together to create slack in the belt.
3. Remove belt.
Installation
1. Replace belt.
2. Tighten two adjustment bolts evenly and maintain
belt alignment. Tighten belt to proper tension (see
table).
3. Tighten four hold-down bolts.
4. Install Ground Drive Belt and tighten to proper
tension (see page 10).
ti19147a
ti19146a
ti19148a
Oil Reservoir Belt
Tension Recommendations
New Belt
Tension 55 +/- 2 Lbf (245 +/- 9 N)
Frequency 114 +/- 2 Hz
Used Belt
Tension 48 +/- 2 Lbf (214 +/- 9 N)
Frequency 106 +/- 2 Hz
Gates Sonic Tension Meter
Settings: M = MASS = 85 g/m
W = # of belts = 1
S = Span = 236 mm
ti19149a
ti19150a
ti19151a