User's Manual

Installation
To reduce the risk of injury, follow the Pressure
Relief Procedure in your Pro Xp manual before
installing this kit.
1. Flush the gun as instructed in your gun manual.
Relieve the pressure.
2. Remove the retaining ring and air cap.
NOTICE
Trigger the gun while removing the nozzle to
help drain the gun and prevent any paint or
solvent left in the gun from entering the air
passages.
3. Trigger the gun while removing the fluid nozzle.
NOTICE
Use non-silicone grease, Part No. 111265, on
the small o-ring (4b). Do not over-lubricate. Do
not lubricate the conductive contact ring (4a).
4. Make sure the conductive contact ring (4a) and
the small o-ring (4b) are in place on the round
spray nozzle (4). Lightly lubricate the small o-ring
(4b).
5. Make sure the e
lectrode needle is finger-tight.
6. Trigger the gu
n while installing the fluid nozzle (4)
with the multi
-tool provided with the gun. Tighten
until the fluid
nozzle seats in the gun barrel (1/8
to1/4turnpa
st hand-tight).
7. Install the r
ound spray diffuser (49) and air cap
(5). Reinsta
ll the retaining ring (6).
NOTE: Items
markedwitha★areshownfor
reference a
nd are not included in the kit.
Figure 1 Round Spray Air Cap, Diffuser, and
Nozzle
2
3A2498A