User's Manual

Accessories

3A2347T 95

Light Tower Kit Installation

1. Turn main power switch OFF.

2. Disconnect cable from ADM, push cable through

plastic shroud, then remove shroud from system.

3. Remove existing grommet (AA) from electrical

enclosure then install new grommet (1204) in its

place.

4. Insert grommet (1202) into hole on the light tower

bracket (1203).

5. Remove bolts (BB) from metal shroud on the sys-

tem then use the bolts (BB) to secure

bracket (1203) to metal shroud.

6. Route light tower cable through hole in

bracket (1203) then use supplied light tower

screws (1201a) to install light tower (1201).

7. Remove electrical enclosure front access door.

8. Route light tower cable through the other hole in the

bracket (1203), then through the grommet (1204)

into the electrical enclosure.

9. Connect light tower cable to MZLP connector

labeled J12.

Air Reservoir Kit, 16W366

This kit allows the system to operate as low as 60 psi

(0.4 MPa, 4 bar).

16W366 Parts

--- Not for sale.

* Metric fitting included in Air Metric Fitting Kit,

24W637, page 103.

Ref Part Description Qty

1501 --- HOSE, nylon (6 ft) 1

1502 100081 BUSHING, pipe 1

1503 113777 TEE, branch 1

1504* 114485 CONNECTOR, male, 3/8 npt 2

1505 155665 UNION, adapter 1

1506 --- TANK, air, accumulator 1

1501

1504

1504*

1503

1505

1506