User's Manual

Electrical Schematics
72 3A2347T
Electrical Schematics
Incoming Power and Terminal
Jumpers
The incoming power and terminal jumpers are specific
to the phase and voltage used. The power type and cir-
cuit breaker size must be correctly set in the ADM. See
Select ADM Settings on page 21.
If changing power type, use the supplied hard metal 2,
3, and 5 terminal jumpers and screws and supplied
jumper wire to jumper the terminals. See Connect Elec-
trical Cord on page 19 for detailed information about
changing terminal jumper locations.
To prevent electric shock and system damage, all
electrical work must be performed by a qualified
electrician.
NOTICE
To prevent severe system damage, ensure terminal
jumpers are installed correctly. See Connect Electri-
cal Cord on page 19.