User's Manual

Repair

3A2347T 65

Replace Fill Cap

Disassembly (see F

. 45):

1. Turn main power switch OFF.

2. Close the bleed-type ball valve installed at the sys-

tem air inlet to relieve all air pressure in the system.

3. Disconnect cable from ADM then remove shroud.

4. Loosen hose clamp on air motor bracket (528) then

remove funnel assembly.

5. Loosen fill sensor jam nut then remove sensor (20)

from fill cap (62).

6. Remove air line (35) from fill cap (62).

7. Loosen upper clamp (13) on rubber housing then

remove fill cap (62).

Reassembly (see F

. 45):

1. Place new fill cap on melter. Align funnel inlet hole

with bracket.

2. Install funnel through air motor bracket (528) then

tighten funnel clamp.

3. Tighten rubber housing clamp (13) to secure fill cap

in place.

4. Connect air line (35) to fill cap (62).

5. Thread fill sensor (20) into fill cap (62). Bottom out

the sensor in the fill cap then back out 1/2 turn.

6. Tighten jam nut on fill sensor (20).

Replace ADM

1. Turn main power switch OFF.

2. Disconnect cable (CC) from bottom of ADM (30).

See F

. 46.

3. Remove ADM from bracket (58).

4. Install new ADM into bracket.

5. Connect cable to bottom of new ADM.

NOTE: ADM may need updated software. See Soft-

ware Update Procedure on page 71.

. 45

ti20760a

. 46

ti20763a