User's Manual

Appendix A - ADM
108 3A2347T
Maintenance
The system will notify the user at the set interval that
maintenance is required. The fields in boxes can be
edited by the user. “Due” and “Current” are both the
number of cycles since the last reset. “Interval” is the set
number of cycles between maintenance notifications.
“Lifetime” is the number of cycles in the lifetime of the
system.
NOTE: The lifetime cycle count will only be reset if the
Advanced Display Module (ADM) is replaced.
Schedule
Use this screen to set times where the system will auto-
matically enable and disable heating. See Select ADM
Settings on page 21.
Advanced 1
Language: Language displayed on the screen.
Date Format: Choose format of the date.
Date: Set the date.
Time: Set the time.
Enter Password: If not “0000”, the Setup screens will
be password protected.
Screen Saver: The screen will go black after the set
amount of time.
Silent Mode: Disable ADM sounds.
Advanced 2
Temperature Units: Units of measure for displayed
temperatures.
Mass Units: Units of measure for mass.
Specific Gravity: Required to convert the volume dis-
pensed to mass dispensed for tracking the total weight
and flow rate.
NOTE: When the specific gravity value is populated, the
total mass dispensed since the last total weight reset is
shown on the Home screen and the mass flow rate is
shown on the Diagnostic screen.