User's Manual
Component Function
3A2091C 9
Component Function
A
Air Regulator Allows regulation of the bead tank air pressure
B
Bead Tank
Holds up to 36 gallons (136 liters) of reflective materials or element for single or
double drop beading
C
Air Accumulator Tank Helps reduce air temperature from compressor
D
Hydraulic Valve Valve to shut off/on the hydraulic fluid to the hydraulic motor
E
Fluid Filter Filters fluid between the fluid source and the spray gun
F
Pressure Drain Valve Relieves fluid pressure when open
G
RPS 2900 Hydraulic Pump Provides fluid to be sprayed through the spray gun
H
Fluid Outlet Supplies fluid from the displacement pump to the spray gun
J
Fluid Inlet Displacement Pump entry for fluid from the paint drums (paint drums not shown)
K
Electrical Junction Box Allows the user access to electrical system
L
18 HP Engine Powers the hydraulic pump and the air compressor
M
Battery Provides power to start the engine and control box
N
Fuel Tank Holds 6 gallons (23 liters) of gasoline
P
Hydraulic Pressure Control Knob Provides adjustment of hydraulic pressure (clockwise increases pressure)
R
Compressor Provides an air supply for the solenoids and pressurizes the bead tanks
S
Hydraulic Reservoir Holds 4 gallons (15.1 liters) of hydraulic oil for the hydraulic pump
T
I/O Cable Carries electronic control signals from the controller to the RoadLazer
W
Programmable Skipline Controller Allows the user to program the operation of the RoadLazer
Y
Air Pressure Quick Connect Allows the user to use pressurized air
AB
Stow Bracket Pin Secures the spray gun boom arm when the RoadLazer is in transport mode
AC
Breather Cap Provides a means for hydraulic reservoir ventilation, oil check, and fill
AD
Adjustable Gun Arm Beam Supports the RoadPak Gun Arm
AE
RoadPak Gun Arm Allows striping on either side of the vehicle at adjustable distances
AF
Bead Spray Gun Sprays beads when commanded by the Controller
AG
Paint Spray Gun Sprays fluid when controller by the Controller
AJ
Simple Guide System Provides an alignment tool for the user
AK
Gun Arm Stow Bracket Allows upright storage of RoadPak gun arm
AL
Gun Arm Stow Plate Allows connection between stow bracket and spray gun boom arm
AM
Trailer Jack
Used to hold Tow-Behind System upright when disconnected from tow vehicle
and during storage
AN
Gun Arm Beam Bracket Supports the slide beam
AP
Wheel Assembly Supports RoadLazer RoadPak trailer
AR
RoadLazer RoadPak Trailer Allows user to tow RoadPak behind a vehicle