User's Manual

Operation
3A2091C 31
Prepare System to Paint
Initial Settings
1. Attach Tow-Behind System ground clamp to earth
ground. See Grounding Instructions, page 13.
2. Fill throat packing nut with TSL to prevent prema-
ture packing wear. Do this each time you spray and
store.
3. Check engine oil level. Add SAE 10W-30 (summer)
or 5W-20 (winter), if necessary.
4. Fill fuel tank.
5. Check hydraulic oil level. Add only Graco Hydraulic
Oil, ISO 46 169236 (5 gallon/18.9 liter) or 207428 (1
gallon/3.8 liter). Hydraulic tank capacity is approxi-
mately 4.0 gallons (15.14 liters).
6. Check oil level in compressor. NOTE: If red dot is
visible, add oil.
7. Verify all hose/fitting connections are tight.
8. Turn hydraulic lines to closed position.
9. Turn pump lever by guns 1/4 turn to OFF position.
10. Place suction tube and drain tube in grounded metal
pail partially filled with flushing fluid. Attach ground
wire to pail and to earth ground.
Approximate
Fill Level
ti5240a
(cold)
ti16447a
Safe Range (cold)
ti5243a
ti15838a
ti15953a