User's Manual

Operation
30 3A2091C
Emergency Shut Off
To shut down the entire Tow-Behind system, set
POWER ON/OFF on the Programmable Skipline Con-
troller to the OFF position.
Load Reflecting Materials
1. Set POWER ON/OFF on Programmable Skipline
Controller to OFF.
2. Set RoadPak engine ignition key to OFF.
3. Relieve air system pressure by opening ball valve
until gauge reads 0.
4. Relieve air pressure in bead tank by turning bead
system valve to OFF position.
5. Remove cover from bead tank.
6. Screen reflective materials to prevent debris from
entering tank.
7. Load bead tank with reflective materials.
Set Up Adjustable Gun Arm
Beam and Gun Arm
1. Unlock gun arm clamp and gun arm beam clamps.
2. Pull gun arm beam to left or right side of vehicle.
Lock slide beam clamps.
3. Remove gun arm from upright stowed position, and
slide to end of gun arm beam. Slowly lower gun
arm, and lock into position with clamp.
ti16425a
ti16423a