User's Manual
Smart Control Operation
26 3A2090C Operation
Operation in Manual Mode
1. Make sure engine is running and engine clutch
switch is on.
2. Use Gun Selector Switches to select guns and
place switch in continuous line position.
3. Press and hold Gun Trigger Control button to spray
a line. Release button to stop spraying.
NOTE: Selected guns will spray even if the striper is not
moving.
Operation in Automatic Mode
Preset Skip Patterns
1. In the AUTOMATIC MODE, the striper is equipped
with Preset Skip Patterns. To select a preset skip
pattern, press MODE button to move to AUTO-
MATIC MODE.
2. Press SETUP button to view preset skip patterns.
3. Use SELECT arrows to mark desired pattern. Press
SETUP key to save and return to AUTOMATIC
MODE display.
4. Use Gun Selector Switches to select guns and line
type.
NOTE: Striper must be moving for guns to activate.
5. With the striper moving faster than 0.3 mph (0.5
kph) press Gun Trigger Control Button to stripe.
Press button again to stop striping or reduce speed
to below 0.3 mph (0.5 kph).
ti9915b
@8A@BD"
!""#
$%&'()
ti25622a
ti18969a
Programmed line pattern
OFF position disengages gun
Continuous line
ti18564a
@8A@BD"
!""#
$%&'()
ti9915b
>-/
##@!#
4"@A!89
s
ti9942b
ti18969a
Programmed line pattern
OFF position disengages gun
Continuous line
ti18564a