User's Manual

Setup/Startup

12 3A2090C Operation

14. Increase pressure control enough to start pump.

Allow fluid to circulate for 15 seconds.

15. Turn pressure down, turn prime valve horizontal.

Disengage gun trigger lock.

16. Hold gun against grounded metal flushing pail. Trig-

ger gun and increase fluid pressure slowly until

pump runs smoothly.

17. Inspect fittings for leaks. If leaks occur, turn sprayer

OFF immediately. Perform Pressure Relief Proce-

dure. Tighten leaky fittings. Repeat Startup, steps

10 - 17. If no leaks, continue to trigger gun until sys-

tem is thoroughly flushed. Proceed to step 18.

18. Place siphon tube in paint pail.

19. Trigger gun again into flushing fluid pail until paint

appears. Assemble tip and guard.

20. Repeat step 19 on second gun for 2-gun models.

SwitchTip and Guard Assembly

1. Engage trigger lock. Use end of SwitchTip (A) to

press OneSeal (B) into tip guard (D), with curve

matching tip bore (C).

2. Insert SwitchTip in tip bore and firmly thread assem-

bly onto gun.

To avoid skin injection injury, do not stop leaks with

your hand or a rag.

15 SEC.

ti3442a

ti6472a

3304c

ti3441a

ti3442a

PAINT

ti3316a

ti3324a

ti6638a

ti3325a

ti3327a