User's Manual

Installation
Non-Hazardous Locations
NOTE: Non-IS I
nformer modules are shipped with a
120 VAC power c
ord (E). Users in areas with another
standard volt
age must provide a power supply
cord with an IE
C 320–C13 female connector. See
Technical Da
ta, page 41, for power requirements..
• The nonintrinsically safe terminals (power rail)
must not be connected to any device which uses
or generates m
ore than 250 vrms or d.c. unless it
has been deter
mined that the voltage has been
adequately is
olated.
Key:
A
Flow Meter, 1/4 npt female inlet/outlet
B
Informer Module
C Powe
r Supply and Cable (6 ft., 2 m), to terminal 3. See Cable Connections, page 12.
D
Meter Cable (50 ft., 15 m), to terminal 4. See Cable Connections, page 12.
E
Power Cord (10 ft., 3 m). See NOTE above.
M
Gr
ound wire and clamp. PN 244524 is included with kits to ground the Informer Module. PN 238909
is
sold separately to ground the meter.
3A2040E 9