User's Manual

Setup Screens
Setup Screens
The Setup Mode
is used to set up a password
(if desired)
and to set parameters for
monitoring fl
uid flow with the Informer. See
Screen Navig
ation and Editing, page 20,for
information
on how to make selections and enter
data.
Setup Screen 1
Use this sc
reen to view and reset the maintenance
totalizer
, set the maintenance target value, and set
the batch a
nd grand totalizer units shown on the Run
Screens.
Maintenance totalizer units, shown on this
Setup Scr
een, are always cc.
Figure 6 Setup Screen 1
Key
Enter the screen to set or change
preferences.
Presstoactivateafieldforeditingor
to accept the highlighted selection on a
dropdown menu.
Move to the right when editing number
fields. Press again to accept the entry
when all digits are correct.
Reset Maintenance Totalizer - resets the
maintenance totalizer to zero.
Maintenance Totalizer - Displays the
current maintenance total in cubic
centimeters.
Set your desired maintenance total target
valueinthisfieldincubiccentimeters.
See Setup Screen 3 to set or disable the
maintenance alarm.
Batch Tota
lizer Units - Select from the
following
drop down options.
Cubic centimeters
Liters
Gallons
Grand Totalizer Units - Select from the
following drop down options.
Cubic c
entimeters
Liters
Gallons
Exit data editing.
Move between Setup Screens, fields on
a screen, or to increment/decrement the
digits when editing number fields.
3A2040E 25