User's Manual

Installation and Setup
6 3A1898B
Electronic Control Setup
The discharge settings can be programmed for
any length of time between 1 to 12 months and
the interval may be changed at any time.
The following instructions assume this is an
existing installation and you are replacing the
lubrication cartridge. If this is a new electronic
control and a first time installation, you may
skip Steps 1- 4.
Installing the Electronic Control Cover
1. Relieve pressure,
page 4.
2. Remove the protec-
tive plastic cover
over the electronic
control. Keep this
cover to reinstall
after setup is com-
plete to protect the display during opera-
tion.
3. If this is an existing installation and you are
replacing the lubrication cartridge turn the
electronic control cover counter-clockwise,
to remove the cover.
4. Turn the cover
clockwise to
secure it to the
lubrication canis-
ter until a corner
of the cover
aligns with the
arrow on the
body.
Setting Up the Electronic Control
1. Repeatedly press
the SET button on
the electronic con-
trol cover until the
number of months
you are setting is
displayed on the
screen.
You are setting the length of time in months
that you want it to take to discharge the
entire 130 cc of fluid in the canister.
NOTE:
The entire volume of the lubricator will be
dispensed in the number of months dis-
played
• (more months = slower discharge).
• (fewer months = quicker discharge).
2. Install transparent cover over electronic
control to protect it from dust and dirt.
3. Write the installation date on the label
located on the side of the lubrication canis-
ter (F
IG. 2).
FIG. 2