User's Manual

Changing the Lubrication Canister
3A1898B 11
Changing the Lubrication
Canister
1. Relieve pressure,
page 4.
2. Unscrew the lubri-
cation canister and
remove from
grease port.
3. Remove the protec-
tive plastic cover over the electronic con-
trol. Keep this cover to reinstall after setup
is complete to protect the display during
operation.
4. Turn the electronic control cover
counter-clockwise, to remove the cover.
Replacement Cansiters
Replacement canisters are available from
Graco. Refer to the chart below to select the
correct canister for your application.
Canister Disposal
1. Use a spanner wrench to separate battery
from lubrication canister.
2. Dispose of the battery and lubrication can-
ister in approved containers, and according
to applicable local and state guidelines.
Read the MSDS to know the specific haz-
ards of the fluids you are using.
Storage
When lubricators are not immediately installed,
they must be stored in a dry, dust free, sunlight
protected room, indoors.
Part No.
Application
24M684 Multi EP-2
24M685 Construction
24M686 Bearing
24M687 Milling
24M688 Food Grade H1
24M689 Synthetic Industrial
24M690 Ultra Spindle
24M691 Multi EP-1