User's Manual

Repair
40 3A1602G
Spout Adapter
The sprayer is supplied with a 40 mm spout adapter.
Follow these instructions to install 38 mm spout adapt-
ers or repair the A and B side spout adapters.
See Pour Spout Adapter, page 49 for parts.
1. Loosen containment knob.
2. Remove adapter.
a. Use a small flat head screwdriver to remove
retaining ring (405) from adapter.
b. Loosen housing (403) from nut cap (402).
c. Slide spout adapter (404), housing (403), plate
(401), and nut cap (402), off fluid tube (P).
d. Remove spout adapter (404) from housing.
Remove nut cap (402).
3. Connect 38 mm or 40 mm spout adapter.
a. Place spout adapter (404) on a flat level sur-
face. Place retaining ring (405) above housing
base (403) and insert the bottom of the housing
in the spout adapter (404).
b. Use two flat head screwdrivers to insert the bot-
tom of the retaining ring (405) in the groove.
After the bottom has gotten started in the
groove, continue to press down on the retaining
ring with one screwdriver and rotate the spout
adapter (404) with your other hand until the
retaining ring snaps in the groove.
c. Install nut cap (402) and plate (AP) on fluid tube
(P).
d. Apply grease on o-rings (406, 407) and slide
over fluid tube threads and recirculation tube.
e. Slide housing (403) on fluid tube (P) and align
orings (4067, 407) in grooves of housing (403).
f. Tighten nut cap (402) on housing (403).
NOTICE
To prevent damage to spout adapter o-ring, gently
remove adapter housing from fluid tube.
FIG. 64
401
402
405
404
407
406
508
403