User's Manual

Flushing
3A1602G 23
9. Purge gun hoses.
a. Disconnect hoses from gun and secure to a pail
of solvent.
b. Turn Recirc/Spray valve A to Spray.
c. Open gun into waste container A.
d. Set function knob to Slow Recirc until hose
is flushed.
e. Set function knob to Stop/Park
.
f. Repeat for B side.
10. Set function knob to Stop/Park
.
11. Solvent flushing is a two step process. Go back to
step 3, drain solvent, and flush again with fresh sol-
vent.
12. Place fluid inlet tubes in a pail of plasticizer or clean
motor oil and circulate fluid through the system.
Leave fluid in the unit.
NOTE: Never leave the unit dry unless it has been dis-
assembled and cleaned. If fluid residue dries in the
pumps, the ball checks may stick the next time you use
the unit.
FIG. 45
TI17136a