User's Manual

Maintenance
3A1602G 21
5. Use solvent to wipe down fluid inlet tubes.
6. Install suction tube caps on each fluid inlet tube and
rest in the containment tray. Tighten the contain-
ment knob to press the bracket against the fluid inlet
tubes.
7. Refer to your separate spray gun manual to perform
the gun shutdown procedure.
8. Wrap hoses around sprayer.
9. Disconnect power cord before moving.
Maintenance
• Check pump wet-cups fluid level daily. Refer to Fill
Wet-cups, page 16.
• Do not overtighten packing nut/wet-cup. Throat
u-cup is not adjustable.
• Keep component A from exposure to moisture in
atmosphere, to prevent crystallization.
• Check desiccant filters weekly. Filter is blue when
fresh, and turns pink when saturated.
• Generally, flush if you will shutdown for more than
three days. Flush more often if material is moisture
sensitive and humidity is high in the storage area, or
if material may separate or settle out over time.
• Close gun fluid valves A and B when not spraying.
Doing this will keep the internal parts of the gun
cleaner and prevent crossover. Clean gun mix
chamber ports and check valve screens regularly.
See spray gun manual.
• Always grease the gun after use until purge air car-
ries grease mist out the front of the gun. Use Part
No. 117773 Grease. See spray gun manual.
• Always grease the inlet tube spout adapters after
use. Use Part No. 117773 Grease and grease gun
supplied with spray gun.
• Remove any material from containment tray with
solvent.
FIG. 37
FIG. 38
Caps
TI17458a
Containment
Knob
TI17459a
FIG. 39