User's Manual

Pressure Relief Procedure

20 3A1602G

Pressure Relief

Procedure

NOTE: If using the Manual 2K gun, refer to the Manual

2K gun instruction manual.

1. Engage piston safety lock.

2. Set function knob to Stop/Park

3. Turn Recirc/Spray valves to Recirc. Fluid will be

returned to material pails. Pumps will move to the

bottom of their stroke. Ensure gauges drop to 0.

Shutdown

NOTE: For longer breaks (more than 10 minutes), use

the following procedure. If you will be shut down for

more than three days, perform the Flushing procedure,

page 22, first.

NOTE: If using the Manual 2K gun, refer to the Manual

2K gun instruction manual.

1. Follow Pressure Relief Procedure.

2. Close gun fluid valves A and B. Doing this will keep

the internal parts of the gun cleaner and prevent

crossover.

3. Shut off power.

4. Loosen rings from pour spouts and remove fluid

inlet tubes from pails. Allow residual fluid to drain

into the appropriate pail.

Trapped air can cause the pump to cycle

unexpectedly, which could result in serious injury

from splashing or moving parts.

FIG. 31

FIG. 32

FIG. 33

TI17127b

TI17133a

FIG. 34

FIG. 35

FIG. 36

TI17135a

Ring

TI17125a