User's Manual

Setup

18 3A1602G

7. Set function knob to Slow Recirc or Fast Recirc

8. When clean solvent exits both recirculation tubes,

set the function knob to Stop/Park

9. Insert inlet tubes into pails. See Connect Fluid

Inlet Tubes, page 18.

10. Set the Recirc/Spray valves to Spray.

11. Run until material exits gun manifold.

Connect Fluid Inlet Tubes

1. Loosen containment knob.

2. Remove suction tube caps and place in containment

tray.

3. Insert each fluid inlet tube through the pour spout on

the appropriate five-gallon pail. Tighten the ring to

the pour spout.

NOTE: Use a drill and mixing blade to mix filled or sepa-

rated materials in the pail before placing fluid inlet tube

into the pail.

FIG. 21

FIG. 22

TI17128b

TI17132a

FIG. 23

NOTICE

To prevent cross-contamination of fluids and equip-

ment parts, never interchange component A (isocya-

nate) and component B (resin) parts or containers.

Label one pail “A” and the other “B”, using the red and

blue labels provided. Always double check which

material you have before placing fluid inlet tube into

the pail.

Ring

TI17125a