User's Manual

3A1302D 3
7. Connect air regulator assembly to bead tank air inlet
and tighten swivel (22).
8. Remove plug (40) from T-fitting (39) assembled to
air tank on RoadPak unit.
If assembling second bead tank to RoadPak frame:
9. Apply thread sealant to fitting (41) and tighten to
T-fitting (39). Apply thread sealant to fitting (41) and
tighten to elbow fitting (24). Connect coupled hose
(42) to fittings (41).
If assembling second bead tank to remote location:
10. Tighten air fitting (29) to T-fitting (39). Tighten air fit-
ting (29) to elbow fitting (24). Cut air hose (31) to
desired length and connect to air fittings (29).
11. Connect dark hose (20) into air fitting (29) and clear
hose (32) to bottom of air regulator (11). Route
hoses through slot on tank bracket.
12. Connect bead hose (not included) to bottom of bead
tank (1).
NOTE: Bead tank kit comes with two hose fittings
(10) and three plugs (9) shipped with hose kit.
ti16805a
22
ti16808a
40
39
41
41
42
24
ti17167a
39
29
29
31
24
ti17168a
ti16806a
29
20
11
32
ti16598a
1