User's Manual

Alarms and Warnings
90 3A1080C
Alarms and Warnings
NOTE: Do not use the fluid in the line that was dis-
pensed off ratio as it may not cure properly.
System Alarms
System alarms alert you of a problem and help prevent
off-ratio spraying. If an alarm occurs, operation stops
and the following occurs:
• Alarm sounds.
• Status bar on the EasyKey shows the alarm E-Code
with a description (see Table 13).
System Warnings
Table 13 lists the System Warning Codes. Warnings do
not stop operation or sound an alarm. They are saved in
the date/time stamped log, which can be viewed on a
PC, using the Web Interface (see manual 313386).
To Reset Alarm and Restart
NOTE: When an alarm occurs be sure to determine the
E-Code before resetting it. See Table 13. If you forget
which E-Code occurred, use the Alarms Screen (page
24) to view the last 10 alarms, with date and time
stamps.
To reset alarms, see Table 14. Many alarms can be
cleared by simply pressing the Alarm Reset
key.
Table 13: System Alarm/Warning Codes
Code Description Details
E-1 Communication Error Alarm Page 91
E-2 Potlife Alarm Page 91
E-3 Ratio High Alarm Page 92
E-4 Ratio Low Alarm Page 93
E-5 Overdose A/B Dose Too Short
Alarm
Page 94
E-6 Overdose B/A Dose Too Short
Alarm
Page 94
E-7 Dose Time A Alarm Page 95
E-8 Dose Time B Alarm Page 95
E-9 Mix in Setup Alarm Page 96
E-10 Remote Stop Alarm Page 96
E-11 Purge Volume Alarm Page 96
E-12 CAN Network Communication Error
Alarm
Page 96
E-13 High Flow Alarm Page 96
E-14 Low Flow Alarm Page 96
E-15 System Idle Warning Page 97
E-16 Setup Change Warning Page 97
E-17 Power On Warning Page 97
E-18 Defaults Loaded Warning Page 97
E-19 I/O Alarm Page 98
E-20 Purge Initiate Alarm Page 99
E-21 Material Fill Alarm Page 99
E-22 Tank A Low Alarm Page 99
E-23 Tank B Low Alarm Page 99
E-24 Tank S Low Alarm Page 99
E-25 Auto Dump Complete Alarm Page 100
E-26 Color/Catalyst Purge Alarm Page 100
E-27 Color/Catalyst Fill Alarm Page 100