User's Manual
Table Of Contents
- Related Manuals
- Equipment Approvals
- System Configuration and Part Numbers
- Warnings
- Important Two-Component Material Information
- Glossary of Terms
- Overview
- EasyKey Display and Keyboard
- Run Mode Screens
- Setup Mode
- ProControl 1KS Integration Specifics
- System Operation
- Meter Calibration
- Color Change
- Alarms and Warnings
- Alarm Troubleshooting
- Schematic Diagrams
- Technical Data
- Graco Standard Warranty
- Graco Information
Setup Mode
32 3A1080C
Option Screens
NOTE: See FIG. 26 on page 28 for a map of the Option
Screens. Detailed screen descriptions follow.
NOTE: Each screen displays the current screen number
and the total number of screens in the group.
Option Screen 1
Flush Volume Check
This field only appears if Solvent Monitor is set to
“Meter” in Configure Screen 5, page 31.
If set to “On”, Minimum Flush Volume will appear in Rec-
ipe Setup Screen 2, page 40.
Flush and Fill Input
If set to “Global”, Color/Catalyst Purge and Color/Cata-
lyst Fill are added to Advanced Setup Screen 1, page
35. Advanced Setup Screen 2 and 3 are added. See
pages 36-38.
If set to “Recipe”, Color/Catalyst Purge and Color/Cata-
lyst Fill are added to Recipe Setup Screen 2, page 40.
Recipe Setup Screen 3, 4, and 7 are added. See
pages 41-42.
K-Factor Input
If set to “Global,” Advanced Setup Screen 4, page 37 is
added.
If set to “Recipe,” Recipe Setup Screen 5, page 42, is
added.
Minimum Material Fill Volume
Enter 0-9999 cc.
Verification Screen
Verification
This screen appears if Flush and Fill Input or K-Factor
Input are changed from “Recipe” to “Global” in Option
Screen 1.
F
IG. 33. Option Screen 1
FIG. 34. Verification Screen