User's Manual

ManualsBrandsGraco ManualsDo-It-Yourself tools3A1080C

Table Of Contents

Related Manuals
Equipment Approvals
System Configuration and Part Numbers
- Models
Warnings
Important Two-Component Material Information
- Isocyanate Conditions
- Material Self-ignition
- Keep Components A and B Separate
- Moisture Sensitivity of Isocyanates
- Changing Materials
Glossary of Terms
Overview
- Usage
- Component Identification and Definition
- ProControl 1KS System Components
EasyKey Display and Keyboard
- Display
- Keypad
- AC Power Switch
- I/S Power
- Potlife Exceeded Audible Alarm
- Graco Web Interface Port
- Ethernet Connection
Run Mode Screens
- Splash Screen
- Status Screen
- Manual Override Screen
- Totals Screen
- Reset Total Screen
- Reset Solvent Screen
- Alarms Screen
- Level Control Screen
Setup Mode
- Password Screen
- Set Up Home Screen
- System Configuration Screens
- Option Screens
- Advanced Setup Screens
- Recipe Setup Screens
- Recipe 0 Screens
- Calibration Screen
ProControl 1KS Integration Specifics
- Discrete I/O vs Network Communications
- Discrete I/O
- Automation Flow Charts
System Operation
- Operation Modes
- Recipe (Color) Change
- Flow Control
- Typical PLC Interaction with ProControl 1KS
- General Operating Cycle
- Mix Manifold Valve Settings
- Start Up
- Shutdown
- Pressure Relief Procedure
- Purging
Meter Calibration
Color Change
- Color Change Procedures
- Color Change Sequences
Alarms and Warnings
- System Alarms
- System Warnings
Alarm Troubleshooting
Schematic Diagrams
- System Pneumatic Schematic
- System Electrical Schematic
- EasyKey Electrical Schematic
Technical Data
Graco Standard Warranty
Graco Information

Run Mode Screens

3A1080C 19

Run Mode Screens

NOTE: See FIG. 10 for a map of the Run screens.

Detailed screen descriptions follow.

Splash Screen

At power up, the Graco logo and software revision will

display for approximately 5 seconds, followed by the

Status Screen (see page 21).

The Splash screen will also momentarily display “Estab-

lishing Communication.” If this display remains for more

than one minute, check that the fluid station control box

circuit board is powered up (LED is on) and that the fiber

optic cable is properly connected (see Installation man-

ual).

NOTE: If the software version of the fluid plate does not

match the version of the EasyKey, the EasyKey will

update the fluid plate, and the fluid plate programming

screen will appear until the update is completed.

IG. 8. Splash Screen

IG. 9. Fluid Plate Programming Screen