User's Manual

Instructions

3A0534F 5

plate) as shown in FIG. 11.

3. Install spring (S) into spring pocket (f).

4. Install Rod (R) into reservoir (2).

5. Slide rod (R) through center of spring (S) and fol-

lower plate (FP).

6. Seat spring in spring pocket in top of reservoir.

7. Compress spring to install reservoir. See Reservoir

Installation instructions.

Reservoir Installation

1. Install new reservoir (2) with vent (g) facing toward

the rear left (h) of the G3 base. See F

IG. 12 for cor-

rect orientation of these parts to ensure proper

installation.

2. Position strap wrench over reservoir and use it to

turn reservoir 1/4 turn clockwise till reservoir will not

turn any farther (F

IG. 12).

FIG. 11

FPS

FIG. 12

NOTICE

Be careful when installing reservoir that o-ring is not

pinched. If the o-ring is not correctly installed,

grease could leak out of the bottom of the G3 reser-

voir.