User's Manual

Instructions

4 3A0534F

Reassembly

Lower O-Ring Installation

1. Coat new o-ring (1) with grease (user supplied) and

install o-ring in bottom groove of ricer plate (b).

2. Replace ricer plate (b), aligning circular sections

with the round bosses in the base.

NOTE: It may be necessary to use a press to seat

the plate properly in the G3 base.

3. Reinstall paddle (c) by turning it counter-clockwise

till tight - hand tighten only (F

IG. 8).

NOTE: If a low level paddle (d) is installed, to pre-

vent damage, hold low level paddle in its full out

position while installing stirring paddle (F

IG. 9).

4. Complete installation following instructions for Top

O-ring and Reservoir installation, page 4.

Top O-ring Installation

1. Coat new o-ring (1) with grease (user supplied).

2. Install o-ring in groove of ricer plate (b) (F

IG. 10).

Follower Plate Installation

If your unit does not have a follower plate, continue

installation instructions with Top O-Ring Installa-

tion, page 5.

1. Verify low level paddle (d) is in full out position as

shown in F

IG. 9.

2. Install follower plate (FP) on stirring paddle (c). Be

sure the seal (FPS) is facing down (toward ricer

FIG. 7

FIG. 8

FIG. 9

FIG. 10