User's Manual

Instructions
3A0534F 3
3. Be sure parts remaining in reservoir were removed
to reuse them for reassembly.
4. Examine follower plate seal referenced in Step 1 for
wear or damage. If it is damaged, it must be
replaced. Part No. 278139 is available from Graco.
Contact customer service to order this part or your
local Graco distributor.
Upper O-Ring Disassembly
If o-ring (a) did not come out of the groove in ricer plate
(b) when reservoir was removed, remove and discard
o-ring according to local codes for proper disposal (F
IG.
4).
The lower o-ring is located beneath the ricer plate
(b). If replacing this o-ring, continue with Lower
O-Ring Disassembly instructions.
If lower o-ring is not replaced, begin Reassembly
instructions starting on page 4.
Lower O-Ring Disassembly Instructions
1. Perform all applicable previous disassembly instruc-
tions for reservoir, follower plate (if applicable) and
upper o-ring.
2. Turn paddle (c) clockwise to loosen and remove it
from G3 base (F
IG. 5).
NOTE: For models that include a Low Level paddle
and/or follower plate only, be careful when removing
stirring paddle from G3 that bearing (f) does not fall
into the unit.
3. Remove ricer plate (b) from G3 base.
4. Remove o-ring (e) located under ricer plate (F
IG. 6).
FIG. 4
a
b
FIG. 5
FIG. 6
c
d
f
b
e