User's Manual

Instructions

3A0533D 3

4. Tighten pump element buy hand and then torque to

50 in. lbs (5.6 N•m) (F

IG. 3).

Adjusting Output Volume

NOTE:

• It may be necessary to repeat the outlet volume

setup procedure after the pump is operating to

re-adjust the volume of dispensed grease.

• The amount of dispensed volume can vary depend-

ing on external conditions such as lubricant temper-

ature and back pressure from downstream

connections. Use the volume adjustments provided

in Table 1 as a starting point and adjust as neces-

sary to ensure desired lubrication dispense.

1. Use a wrench to turn pump element counter-clock-

wise to loosen.

2. If needed, remove or insert spacers to achieve

required pump output volume.

• Pump volume control is set using either no (0)

spacers, 1 or 2 spacers (F

IG. 4).

• Do not use more than 2 spacers on any pump

element.

Table 1: Output Volume

IG. 3

No. Spacers

Output Volume / Minute

cubic inches cubic cm

00.2474.0

10.182 3.0

20.1172.0

IG. 4