User's Manual

All written and visual data contained in this document reflects the latest product information available at the time of publication.

Graco reserves the right to make changes at any time without notice.

Original instructions. This manual contains English. MM 3A0523

Graco Headquarters: Minneapolis

International Offices: Belgium, China, Japan, Korea

GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441

www.graco.com

6/2010, revised 1/2012

10. Install these two banjo assemblies in remaining

open pump elements (b) and (d).

11. Install tube (1) (with 2 bends) around the back side

of the G3 pump between the dual banjo fitting

installed on the right side of the G3 pump and the

banjo fitting installed on the left side of the G3 pump

(viewed from the front) as shown in F

IG. 9.

12. Install tube (2) (1 bend) between the dual banjo fit-

ting installed on the right side of the G3 pump and

the banjo fitting installed on the front of the G3 pump

(viewed from the front) as shown in F

IG. 9. It may be

necessary to loosen the banjo fitting to install this

tube.

13. Tighten tube nuts (3), wrench tight only.

14. Tighten banjo bolts (6 and 7) to 35 ft. pounds (45.7

N•m) at each location.

15. Apply thread sealant to threads of plug (10). Install

plugs in unused outlet locations (F

IG. 6).

IG. 9